Electric Shears & Nibblers

Cutting metal roofing and flashing cleanly is what separates a tight, weathertight edge from one that corrodes early. Electric shears and nibblers let our crews cut panels, trim, and flashing to exact lines without deforming the metal, so the factory coating and the panel edge stay intact rather than getting chewed up by a slower, cruder cut.

Where This Tool Fits on a Job

These cuts happen alongside other on-site metal work, not on their own:

Portable Sheet Metal Brakes — bend the custom flashing, drip edge, and trim that the shears and nibblers first cut to size.
Mechanical & Hand Seamers — lock standing seam panels to spec once the panel edges have been shaped cleanly.
Tin Snips & Hand Seamers — handle the tight hand-fit cuts around chimneys, sidewalls, and valleys that a powered tool cannot reach.

Why the Edge Matters

A burred or bent cut edge is where rust and leaks tend to start on a metal roof. Clean shear and nibbler cuts keep panel edges straight and the coating unbroken, which is part of why standing seam and metal trim installed this way holds up to Florida's sun, rain, and wind over time.